Documentation for SLiM function initializeSLiMModelType, which is a
method of the SLiM class Initialize.
Note that the R function is a stub, it does not do anything in R (except bring
up this documentation). It will only do
anything useful when used inside a slim_block function further
nested in a slim_script
function call, where it will be translated into valid SLiM code as part of a
full SLiM script.
initializeSLiMModelType(modelType)An object of type string. Must be of length 1 (a singleton). See details for description.
An object of type void.
Documentation for this function can be found in the official SLiM manual: page 654.
Configure the type of SLiM model used for the simulation. At present, one of two model types may be selected. If modelType is "WF", SLiM will use a Wright-Fisher (WF) model; this is the model type that has always been supported by SLiM, and is the model type used if initializeSLiMModelType() is not called. If modelType is "nonWF", SLiM will use a non-Wright-Fisher (nonWF) model instead; this is a new model type supported by SLiM 3.0 and above (see section 1.6). If initializeSLiMModelType() is called at all then it must be called before any other initialization function, so that SLiM knows from the outset which features are enabled and which are not.
This is documentation for a function in the SLiM software, and has been reproduced from the official manual, which can be found here: http://benhaller.com/slim/SLiM_Manual.pdf. This documentation is Copyright © 2016-2020 Philipp Messer. All rights reserved. More information about SLiM can be found on the official website: https://messerlab.org/slim/
Other Initialize:
Init,
initializeAncestralNucleotides(),
initializeGeneConversion(),
initializeGenomicElementType(),
initializeGenomicElement(),
initializeHotspotMap(),
initializeInteractionType(),
initializeMutationRate(),
initializeMutationTypeNuc(),
initializeMutationType(),
initializeRecombinationRate(),
initializeSLiMOptions(),
initializeSex(),
initializeSpecies(),
initializeTreeSeq()
## This just brings up the documentation:
initializeSLiMModelType()